[UPDATED 2024] NSE6_FSW-7.2 dumps Free Test Engine Verified By Certified Experts
Realistic NSE6_FSW-7.2 Accurate & Verified Answers As Experienced in the Actual Test!
NEW QUESTION # 27
How is traffic routed on FortiSwitch?
- A. ASIC hardware routing can only handle dynamic routing, if supported.
- B. Hardware-based routing on FortiSwitch is handled by the CPU.
- C. Layer 3 routing can be configured on FortiSwitch, while managed by FortiGate.
- D. FortiSwitch looks up the hardware routing table and then the forwarding information base (FIB).
Answer: D
NEW QUESTION # 28
What is the role of a device that is simultaneously functioning as both the distribution and core in the hierarchy network model?
- A. POE with high density FortiSwitch
- B. FortiGate managing FortiSwitch
- C. FortiSwitch functioning as standalone
- D. HA backup FortiGate managing FortiSwitch
Answer: B
NEW QUESTION # 29
Which QoS mechanism maps packets with specific CoS or DSCP markings to an egress queue?
- A. Queuing for egress traffic
- B. Classification for ingress traffic
- C. Marking for ingress traffic
- D. Rate limiting for egress traffic
Answer: B
NEW QUESTION # 30
Which interfaces on FortiSwitch send out FortiLink discovery frames by default in order to detect a FortiGate with an enabled FortiLink interface?
- A. All ports have auto-discovery enabled by default.
- B. The last four switch ports on FortiSwitch have auto-discovery enabled by default.
- C. No ports are enabled by default for auto-discovery. This must be configured under config switch interface.
- D. The ports with auto-discovery enabled by default are dependent upon the FortiSwitch model.
Answer: A
NEW QUESTION # 31
Which two statements about 802.1X authentication on FortiSwitch ports are true? (Choose two.)
- A. All devices connecting to FortiSwitch must support 802.1X authentication.
- B. A security policy is used to apply 802.1 authentication on a port.
- C. A local user database must be used to authenticate devices using the 802.1X authentica-tion protocol.
- D. All hosts behind an authenticated port are allowed access after a successful authentica-tion.
Answer: B,D
NEW QUESTION # 32
Exhibit.
port24 is the only uplink port connected to the network where access to FortiSwitch management services is possible. However, FortiSwitch is still not accessible on the management interface. Which two actions should you take to fix the issue and access FortiSwitch? (Choose two.)
- A. You should use VLAN ID 4094 as the native VLAN on port24.
- B. You must add port24 native VLAN as an allowed VLAN on internal.
- C. You must allow VLAN ID 4094 on port24, if management traffic is tagged.
- D. You must add VLAN ID 200 to the allowed VLANS on internal.
Answer: A,C
NEW QUESTION # 33
Which two statements about managing a FortiSwitch stack on FortiGate are true? (Choose two.)
- A. A FortiLink interface must be enabled on FortiGate.
- B. Only a hardware-based FortiGate can manage a FortiSwitch stack.
- C. FortiSwitch must be operating in standalone mode before authorization.
- D. The switch controller feature must be enabled on FortiGate.
Answer: A,D
NEW QUESTION # 34
What can an administrator do to maintain a FortiGate-compatible FortiSwitch configuration when changing the management mode from standalone to FortiLinK?
- A. Use a migration tool based on Python script to convert the configuration.
- B. FortiGate automatically saves the existing FortiSwitch configuration during the FortiLink management process.
- C. Register FortiSwitch to FortiSwitch Cloud to save a copy before managing with FortiGate.
- D. Enable the FortiLink setting on FortiSwitch before the authorization process.
Answer: C
NEW QUESTION # 35
Refer to the exhibit.
Core-1 and Access-1 are managed and authorized by FortiGate-1. which uses port4 as the FortiLink interface. After FortiGate authorizes and manages Core-2. Port1 status becomes STP discarding.
Why is port1 in the discarding state?
- A. Access-1 is the root bridge and can only have one root port.
- B. Core-2 has the lowest bridge priority.
- C. Core-1 and Core-2 do not have MCLAG configuration.
- D. port1 on Core-2 is discarding only management traffic.
Answer: C
NEW QUESTION # 36
To enhance service in emergency situations, to which LLDP-MED Type-Length-Values does Forti-Switch advertise to IP phones?
- A. Network policy
- B. Power management
- C. Location
- D. Inventory management
Answer: D
NEW QUESTION # 37
Refer to the exhibit.
Which two statements best describe what is displayed in the FortiLink debug output shown in the exhibit? (Choose two.)
- A. FortiSwitch is discovered and authorized by FortiGate.
- B. FortiSwitch is sending FortiLink heartbeats to FortiGate.
- C. FortiSwitch is in a waiting state to join the stack group on FortiGate.
- D. FortiSwitch is ready to push its new hostname to FortiGate.
Answer: A,B
NEW QUESTION # 38
Refer to the configuration:
Which two conditions does FortiSwitch need to meet to successfully configure the options shown in the exhibit above? (Choose two.)
- A. The Dort full speed prior to the split was 100G QSFP+.
- B. The FortiSwitch model is equipped with a maximum of 54 interfaces
- C. FortiSwitch would need to be rebooted.
- D. The split port can be assigned to a native VLAN.
Answer: B,C
NEW QUESTION # 39
Which drop policy mode, if assigned to a congested port, will drop incoming packets until there is no congestion on the egress port?
- A. Tail-drop mode
- B. Weighted round robin mode.
- C. Strict mode
- D. Random early detection mode
Answer: A
NEW QUESTION # 40
Exhibit.
You need to manage three FortiSwitch devices using a FortiGate device. Two of the FortiSwitch devices initiated a reboot after the authorization process. However, the FortiSwitch device with the configuration shown in the exhibit. did not reboot All three devices completed FortiLink manage-ment authorization successfully.
Why did the FortiSwitch device shown in the exhibit not reboot to complete the authorization pro-cess?
The management mode was set to use FortiLink mode.
- A. The management mode was set to use FortiLink mode.
- B. The system time is not in-sync and is using a non-default value
- C. The FortiSwitch device is scheduled to reboot as part the authorization process
- D. Switch auto-discovery is enabled.
Answer: A
NEW QUESTION # 41
Which Ethernet frame can create Layer 2 flooding due to all bytes on the destination MAC address being set to all FF?
- A. The broadcast Ethernet frame
- B. The multicast Ethernet frame
- C. The anycast Ethernet frame
- D. The unicast Ethernet frame
Answer: A
NEW QUESTION # 42
What feature can network administrators use to segment network operations and the administration of managed FortiSwitch devices on FortiGate?
- A. Multi-chassis link aggregation trunk
- B. FortiGate multi-tenancy
- C. FortiGate clustering protocol
- D. FortiLink split interface
Answer: B
NEW QUESTION # 43
Which statement about 802.1X security profiles using MAC-based authentication mode is true?
- A. FortiSwitch allows connectivity to all hosts connected to a port, if one host is authenticated.
- B. FortiSwitch performs faster when using this security mode on the ports.
- C. FortiSwitch must communicate with the RADIUS server to authenticate devices
- D. FortiSwitch can grant each device a different access level based on the credentials provided
Answer: D
NEW QUESTION # 44
Which statement about the IGMP snooping querier when enabled on a VLAN is true?
- A. All other indirectly connected switches will be unable to get IGMP multicast traffic.
- B. IGMP reports on the VLAN are forwarded to all switch ports.
- C. Active multicast receiver entries are aging on each IGMP query sent on the VLAN
- D. The setting can only be enabled using the FortiSwitch CLI.
Answer: A
NEW QUESTION # 45
......
Fortinet NSE6_FSW-7.2 Exam is a certification program that validates the skills and knowledge of network security professionals in deploying and managing FortiSwitch products. Fortinet NSE 6 - FortiSwitch 7.2 certification is recognized worldwide and is highly valued in the IT industry. Passing NSE6_FSW-7.2 exam is an excellent way for network security professionals to demonstrate their expertise and enhance their career prospects.
Latest Fortinet NSE6_FSW-7.2 Practice Test Questions: https://prepaway.vcetorrent.com/NSE6_FSW-7.2-valid-vce-torrent.html